Blog / Holes in top case and charger connected
These past few days I've been busy again. Got a reply from the RDW saying it's no problem that a few components will be placed in the top case and that there will be high voltage wires coming out of it and sticking out a bit. So this is all allowed, just has to be done in a safe way of course.
First I started making some pass through holes for the wires in the top case. I just don't know whether I'll keep using these rubbers or use cable glands again. With the rubbers the wires won't stick out as much.
Also bought some new heatshrink so I could continue again making the wires for the charger. There are also connectors inbetween so I can disconnect the charger from the batteries just in case it's ever needed.
Here with the connectors connected. Because of the rubbers that are all around it stays completely waterproof.
Meanwhile I have also done some smaller things. The new handle switch is attached and soldered all of the wires for the led buttons.
This weekend I'll start attaching all of the components in the top case.